Birmingham to Belfast in the XT
  Sometimes delivering a trike to a customer can turn out to be quite an adventure...
Dead Sea Flight
  Flying from the north of Tel Aviv to the Dead Sea in a microlight is nothing short of a spectacular adventure...
Airborne in Israel
  Fly to the desert, then on the way back park in a shopping center carpark for a coffee, there is...
XT-912's in Fairbanks Alaska
  Extreme temperatures, extreme terrrain...
Radio controlled Microlight on YouTube
  This is one of the best we have seen so far...
The XT-582 in France
  Photo's by Philippe Tisserant. The article also written by Phillipe is featured on the microlight page in French..
Italy! With Herbert Hofbauer and Micky Mazzolain
  Airborne now flying in Italy...
France - Redback featured in Vol Moteur
  Philippe TISSERANT made the test of Redback, good article...
 

 

AirBorne Newsletter
Enter your email address to subscribe to the AirBorne Newsletter


 

   

 

   

New Maintenance Bulletin

September 2009 SB007 It has been brought to the attention of Airborne that a rear axle - Airborne part # 108452 - HUB AXLE EDGE XT TYPE 2, has been found to be significantly cracked at the tapped locking bolthole. The aircraft involved was a XT 912 tourer edition with approximately 250 service hours. The hollow axle has already been replaced with a solid axle with significantly higher yield strength in trike serial numbers above XT-912-0245 for the 912 XT series and XT-582-0043 for the 582 XT series. This was as part of the tundra model approval process. Click the pdf link for nore details. .89 Kb download